![]() ![]() The following commands can get you the MAC address of your network interface in Linux. These commands are safe to run without changing anything. Here are some methods to get the MAC address. So using appropriate hardware is a good point to start at.How to list MAC address on Linux is a commonly asked question during a Linux job interview. Monitor mode interfaces always work on a "best effort" basis. However, not all hardware fully supports this as not all hardware can be configured to show all packets while in one of the other operating modes. ![]() With mac80211, it is possible to have a network device in monitor mode in addition to a regular device, this is useful to observe the network whilst using it. This mode is useful to see what's going on on the network. All incoming packets are handed over to the host computer completely unfiltered. Monitor mode is a passive-only mode, no frames are transmitted. Several wireless modes you can access by "iw" are described here. The "iw" provides you pretty simple access to wireless configuration and also monitor mode, see here. While moving over to edimax EW-7711UAN (RT2870/RT3070 - rt2800usb) turned out to work like charm.Īs I understood the rtl8188cus are not initially supported by cfg80211, mac80211, nl80211 and thus you might have to compile the drivers yourself to have some wireless features as "iw" at hand. As far as I can tell, I did use the same adapters and had problems setting up a raspi to raspi adhoc connection with these adapters - see here. You can find out if your adapter provides this capability here. I guess you need the wifi monitor feature.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |